How do I clone in a Rainforest 242?How do I clone in a Rainforest 242? Contributed by Highgrade:
Youâ€™ll need 42 net pots with neoprene inserts.
-Cut the insert on one side to the hole in the middle to ease removing the rooted cuts without damaging the roots.
-Fill with distilled water to recomended level and add 4 ml per gallon of Bâ€™cuzz Root Stimulator.
-Take the cuttings using the normal proceedure, dip in a rooting gel (Clonex) and insert the cutting so the bottom protrudes approx. 1â€. Use a piece of cotton or makeup sponge to hold cut in place.
-Be sure thereâ€™s a net pot in every hole to prevent light getting to the solution. Use a netcup with cover on any empty sites.
-Add a fully submersible aquarium heater set to 78f through one of the net pots to speed the rooting process up.
-Plug the unit in and run 24/7 until rooted, usually 6-10 days depending on strain. Top off the reservoir with distilled water as needed to maintain correct level.
DO NOT allow the roots to grow into the motor/mister or you WILL burn the motor up.